Coil Width 15" to 30" (380mm to 760mm) (30” coil requires
remote decoiler or expandable reel)
Materials Formed Steel 30 ga. to 22 ga. (.3mm to .8mm)
(painted, galvanized, aluminized)
Aluminum .019” to .040” (.5mm to 1.0mm)
Copper 16 oz. to 20 oz. 3/4 Hard
(.5mm to .7mm)
Stainless 26 ga. (.5mm)
OPTIONS - SSP MULTIPRO
Program 50 different lengths with quantities from 1 to 999. Machine will automatically run, measure, cut and re-start after panel is removed from shear.
Run Out Table
Conveyer style table attaches to shear and is used to support panel as it exits the machine. Two individually adjustable legs allow variation in height from 25” to 43”. Available in connectable 10 ft. sections.
Forming stations mounted on aluminum rails used to form various panel profiles. Includes shear dies.
Used for holding coil. This arbor expands to the inside diameter of the coil for faster, easier loading. Can accommodate coils with 16” to 20” ID. Capacity is 3,000 lbs. when used with Dual Overhead Reel Stand or Single Free Standing De-Coiler.
NATM Compliant, 12,000 lb. tandem axle trailer used for towing any NTM roofing machine directly to the jobsite. Equipped with crane lifting eyes, 4 drop-foot jack stands and electric brakes w/ breakaway kit.
Dual Overhead Reel Stand
Machine mount overhead stand for holding up to two Expandable Arbors with coil or two De-coiler Reels with coil for a combined total capacity of 6,000 lbs.
Single Free Standing De-Coiler
A Remote stand used at the entry end of the machine to hold one Expandable Arbor with coil or one De-Coiler Reel with coil. Total capacity 3,000 lbs.
Shown with optional DR01-EX
Clip Relief Rollers
Used to help hide screws and bases of clips by forming an offset down both corners of the panel.
Hand held device used to single-lock mechanically seamed panels.
Hot Melt Interface
Electro/mechanical interface for Hot Melt Technologies sealant injection system. Used to inject sealant into female leg of panel as it exits the shear.
Pencil, Bead, V and Straition Rollers
A variety of ribs used to aesthetically enhance standing seam panels.
Used to mount additional rib or striation rollers making changeovers fast and simple.
Profile and Machine
Select X mark to
connect to .PDF drawing for each panel Requires that Adobe Reader be installed